Passat B6 TPMS (ABS style)

Parts that you need:

1.Button for TPMS and a few wires.
2. You can buy kit on the internet for 15-20$.
3*. ABS module that supports this type of TPMS
4. VCDS (for coding)
===================================


CODING :


How you can check if your ABS module supports :
Take your VCDS and
1. go to ABS module,
2. click CODING
3 REMEMBER the number that is already there (write it down, or take a photo)
4. That number +2048 (for example: 29000+2048).



Now you will write that new number and you will click to code it.
You have TWO ways now,
1. coding accepted and you will be able to continue and you will hear ding on your cluster.





2. coding will not be accepted with messagge error (coding rejcted, request out of range).  




1. If the code is rejcted, your ABS module doesnt support this type of TPMS.
2. If the code is accepted, you will have to wire PIN 4 (red wire) wire to ABS module PIN 16. 




3. PIN 3 : illumination (tapped from an adjacent button)

4. PINS: 5 & 6 : ground (tapped from an adjacent button)

IMPORTANT:
GO TO GATEWAY, coding list and enable address 4C Tire pressure II. (if you don't do this, it wont work). Also, uncheck Tire pressure monitoring (TPMS/7K6) installed. (address 65). 





After you do this step, you can press the TPMS button and hold it for 3 to 4 seconds and you will hear "ding" on your instrument cluster.

Also, TPMS icon will appear now,  when you start the car.



Your TPMS is ready for using, you can test it, deflate one tyre and drive a little bit and it will show you icon on the instrument cluster warning you for lower tire pressure.